Stephen
If an etched part is not sufficient
please contact us.
Electroformed shadow masks micro-molds
and components routinely achieve sizes
and tolerances in the low micron level
-Mike
_______________
Mike Bigelow
Technical Sales
DRC - Metrigraphics
60 Concord Street
Wilmington, MA 01887 USA
Tel: + (978) 658-6100 ext. 3063
Fax: + (978) 657-7765
-----Original Message-----
From: Klauder, Jr., Philip R. [mailto:[email protected]]
Sent: Friday, May 10, 2002 7:22 AM
To: '[email protected]'
Subject: RE: [mems-talk] Shadow masks
Try:
Photo Etch Technologies
978-805-5000
Lowell Mass
Phil Klauder
215-646-7400 x2151
-----Original Message-----
From: Stephen Bart [mailto:[email protected]]
Sent: Thursday, May 09, 2002 6:05 PM
To: [email protected]
Subject: [mems-talk] Shadow masks
I am looking for vendors who can construct a 6 in shadow mask with 1 mil
(25um) or better
resolution.
Any suggestions?
--
*******************************************************************
Stephen F. Bart, Ph.D.
Technical Fellow, Core Technology Development
Coventor, Inc.
625 Mount Auburn Street
Cambridge, MA 02138 USA
*******************************************************************
_______________________________________________
[email protected] mailing list: to unsubscribe or change your list
options, visit http://mail.mems-exchange.org/mailman/listinfo/mems-talk
Hosted by the MEMS Exchange, providers of MEMS processing services.
Visit us at http://www.mems-exchange.org/
_______________________________________________
[email protected] mailing list: to unsubscribe or change your list
options, visit http://mail.mems-exchange.org/mailman/listinfo/mems-talk
Hosted by the MEMS Exchange, providers of MEMS processing services.
Visit us at http://www.mems-exchange.org/
