Minimum feature size using wet etching - 3micro-m?
Martyn Gadsdon
2006-09-19
Dear All,
I am trying to make a nanowire grating using a simple process. I am spinning
a layer of photoresist on top of a ~50nm layer of silver or aluminium. The
photoresist is then exposed and developed to have a sinusiodal profile, of
between 200 and 300nm pitch, where the troughs of the profile expose the
metal underneath. I then aim to etch the exposed areas of metal using
typical chemistries such as H3PO4:HAc:HNO3:H2O to leave an array of parallel
metallic wires of the same pitch. However, I seem to be having problems and
never seem to be able to etch the exposed areas.
I have looked into this on the web and came across a short presentation.
The link is:
ccms.ntu.edu.tw/~chihiwu/ch09%20rev3.ppt
and on the slide discussing the disadvantages of wet etching they state:
"Can’t pattern sub-3micro-m feature"
I have worked out they are at the National Taiwan University, but I can not
find the actual author's name or email address to enquire directly to them,
so I thought I'd try to see if anyone else can confirm their statement.
Can anyone tell me if this is correct and may be the reason why I cannot wet
etch my 200-300nm profiles, and if so perhaps provide a reference I can look
up and quote.
Thank you very much for your time.
Martyn Gadsdon