Dan--
HF-nitric-water or HNA silicon isotropic wet etchants may work, but are
notoriously nonuniform due to loading effects.
Nonuniformity is greatly reduced by agitation. They also tend to have lower
etch rate with use, leading to poor repeatability.
I would expect an SF6 plasma to be be more repeatable, because you always
have fresh etchant (F radicals) being formed in the plasma.
Plasma etches tend to etch faster at the outside of the wafer due to less
loading there.
I'd try a pressure at the lower end of your system's range for the best
uniformity.
I'd try a low power (say 50 or 100 W) for more isotropic character.
Another option is XeF2 plasmaless isotropic silicon etching. With the
homemade systems I have used, this is extremely nonuniform.
Xactix, a commercial vendor, may have this problem licked.
--Kirt Williams
----- Original Message -----
From: "Chilcott, Dan W"
To:
Sent: Wednesday, June 27, 2007 11:02 AM
Subject: [mems-talk] Isotropic silicon etch
To All,
I am looking for a well controlled isotropic silicon etch for etching 2 um
deep features. I do not believe that a timed plasma etch would be controlled
enough for this application. I am looking for a control of better than 0.5
um from lot to lot and across the wafer. Any ideas?