Hi all,
I have to track the crystallographic changes of BST films on both single
crystal and polycrystalline wafers as a function of annealing. I was
planning on using normal XRD theta-2theta scans for the single crystal wafer
as I don't expect that much change in the orientation of the crystal in the
single crystal as a function of annealing.
For the polycrystalline film, I was planning on using a Grazing Incidence
XRD method since the normal XRD method will yield very low intensity peaks
for my film on Alumina. However, I have been told that when
polycrystalline films are annealed, the position/orientation of a given
grain may change and the maximum intensity location may change making it
hard to track the maximum intensity as a function of annealing. The same
person recommended the use of texture scans for this case.
Can any one comment on this? Does any one have a procedure for doing a
texture scan? If so, what is the advantage? Any reference material will be
greatly appreciated.
--
EVELYN BENABE
Graduate Research Assistant
RF Microsystems Research Group
University of South Florida
4202 East Fowler Avenue
Tampa, FL 33620
Office: ENB 412
Office Phone: (813)-974-4851