I was wondering if anyone has a recipe for AZ5214 as a negative photoresist
(or any other negative photoresist) that has good step coverage, and overcut
sidewalls.
I have been trying for a while to use positive photoresist as a continuity
layer that resides between a MMIC chip set in a cavity and a Ti/Au seedlayer
for electroplating. I deposit KMPR on top of the seed layer as an
electroplating mold and the solvents in the KMPR react with the positive
photoresist. It doesn't seem to matter than I have thickened my seed layer
in attempts to better isolate the two layers.
So I would like to try and use a negative resist which hopefully will hold
up better to the KMPR. But I still need good step coverage and a good,
overcut sidewalls so my seed layer is still continuous.
Thank you,
Parrish