Hi Sheng
Are you using any thinner with polyimide, then look for the concentration
of both. I had the same problem about couple of years back and a ratio of
1:1 of polyimide and thinner worked well.
Hamood
----------------------------------------
From: "Sheng Zhang"
Sent: Monday, November 19, 2012 11:35 PM
To: "mems-talk"
Subject: [mems-talk] Polyimide / glass adhesion failure
Hi,
I'm having trouble getting good adhesion between polyimide and glass.
One type of failure occurs when curing the sample at 350C and there are
bubbles occurring under the polyimide film.
Another type of failure is when I immerse the cured sample in brine for a
long time, the polyimide film starts to peeling off.
I use polyimide 2610. 1500 rpm for 30sec, soft bake at 90C for 2 min then
150C for 2min. Followed by high temp curing.
Any suggestion is appreciated!
THanks!
_______________________________________________
Hosted by the MEMS and Nanotechnology Exchange, the country's leading
provider of MEMS and Nanotechnology design and fabrication services.
Visit us at http://www.mems-exchange.org
Want to advertise to this community? See http://www.memsnet.org
To unsubscribe:
http://mail.mems-exchange.org/mailman/listinfo/mems-talk
_______________________________________________
Hosted by the MEMS and Nanotechnology Exchange, the country's leading
provider of MEMS and Nanotechnology design and fabrication services.
Visit us at http://www.mems-exchange.org
Want to advertise to this community? See http://www.memsnet.org
To unsubscribe:
http://mail.mems-exchange.org/mailman/listinfo/mems-talk