I'm currently using photoresists uv26. I need to reflow the resist. But I tried
several temperature still it couldn't hit the profile I want. At lower
temperature like 165C the reflow is not enough; when I try to go higher like
180C the resist burnt.
Any comments or advice about this photoresists is very much welcomed.
Thank you in advance.
Sent from my iPhone
Hosted by the MEMS and Nanotechnology Exchange, the country's leading
provider of MEMS and Nanotechnology design and fabrication services.
Visit us at http://www.mems-exchange.org
Want to advertise to this community? See http://www.memsnet.org