Vcuum chuck pressure? How to prevent wafer breaking?
Nathan McCorkle
2013-12-06
I am trying to build a vacuum chuck for spinning, and can't figure out
if a common laboratory roughing vacuum pump would break a silicon
wafer. There is some distance from the center of the chuck to the
O-ring(s), but how much? And the vacuum will never apply more than
14.7 PSI (at sea level), right?
This mentions silicon surviving >10000 PSI, but is that an ingot or
rod or wafer, I can't tell.
http://www.me.berkeley.edu/~lwlin/me119/papers/paper9.pdf
--
-Nathan
_______________________________________________
Hosted by the MEMS and Nanotechnology Exchange, the country's leading
provider of MEMS and Nanotechnology design and fabrication services.
Visit us at http://www.mems-exchange.org
Want to advertise to this community? See http://www.memsnet.org
To unsubscribe:
http://mail.mems-exchange.org/mailman/listinfo/mems-talk