I would use photoresist if you can make it thick enough for your nitride-to-
photoresist selectivity.Chromium will work, but in my experience using it as a
mask for oxide in SF6 RIE, a little of the Cr will be sputtered off and be
redeposited on the area you're trying to etch, causing micromasking. --Kirt
Williams
On Thursday, September 10, 2015 4:29 PM, Yuan Jia
wrote:
Hi All
I have a quick question, I am trying to etch through 300 nm of silicon
nitride using SF6 dry etch, and I am considering using 50 nm of chrome as
mask layer, will this mask layer survive the etching?
Or is there a better mask layer material?
Thanks very much
Best Regrads
--
Yuan Jia
Mechanical Engineering Department
Columbia University
_______________________________________________
Hosted by the MEMS and Nanotechnology Exchange, the country's leading
provider of MEMS and Nanotechnology design and fabrication services.
Visit us at http://www.mems-exchange.org
Want to advertise to this community? See http://www.memsnet.org
To unsubscribe:
http://mail.mems-exchange.org/mailman/listinfo/mems-talk
_______________________________________________
Hosted by the MEMS and Nanotechnology Exchange, the country's leading
provider of MEMS and Nanotechnology design and fabrication services.
Visit us at http://www.mems-exchange.org
Want to advertise to this community? See http://www.memsnet.org
To unsubscribe:
http://mail.mems-exchange.org/mailman/listinfo/mems-talk