Dear MEMS experts,
I would like to get some advice about Au wire bonding, as I am new to
the field of packaging.
I wish to bond to Al pads on my chip, sputter-deposited onto PZT films
(1 micron thick). I have tried this, but have so far failed: either
the first ball bonding does not stick to my Al film, or this film
sticks to the Au wire and lifts off from the PZT film surface. I have
tested different power and time settings, but again, all in vain.
I am using 1000A thick Al pads, and I am slightly reluctant to use a
thicker film, since the whole structure is already rather stressed.
Any comments, suggestions, and information, like the conventional film
thickness range and materials used for top metallisation, are most
welcome. I thank you all for your time.
Marvin
______________________________________________________
Get Your Private, Free Email at http://www.hotmail.com