Hi everyone
I'm facing a severe problem of stripping off of the patterned Post
Exposed Baked resists [negative resist, for both SU-8 25, SU-8 100 ]when
the wafer is immersed into a BOE solution.
I am following the receipe bellow for SU-8 100 from MicroChem
Substrate: SiO2 over Si
Clean: using acetone and methanol in an ultrasonic bath, rinsed in a DI
tank.
Dehydration Bake: at 200C, over a hotplate, for 10 min
Spin Coat: for 10 sec upto 500rpm/s and then 30 sec upto 3000 rpm/s
Pre Exposure Bake: using hot plate,10 min at 65C, then 30min at 95C
Exposure: Sufficient [e.g. 60 sec UV exposure in a Cobilt Alligner]
Post Exposure Bake: using hot plate 3 min at 65C, then 10 min at 95C
Develop: 10 to 15 min in Nano SU-8 developer
Rinse and Dry: Rinsed with IPA and Nitrogen blow dried.
But when i dip this wafer into BOE, the patterned resist just comes off.
Where is the mistake that i'm doing in all those steps??
I'd appriciate any sort of suggestion as i need to overcome this problem.
Thanks
M A Hadi
CISM- The Ohio State University
Columbus, Ohio
------------------------------------------------------------------------
Get your FREE download of MSN Explorer at http://explorer.msn.com