Hello,
We have used the Wax process several times and it works well. But, I would
be careful about removing the wax with a pirahna clean, as this might remove
your PZT. You can use Xylene to remove the wax. Good Luck.
Charles Ellis...
Auburn University Microelectronics Laboratory
----- Original Message -----
From: "Ralph Jih"
To:
Sent: Thursday, December 13, 2001 5:53 AM
Subject: [mems-talk] How to protect the PZT thick film in KOH etchant?
> Dear MEMS colleagues,
>
> Does any one know how to protect the PZT thick film(about 30um) in KOH
> ecthant?
> One side of the wafer is the PZT pattern,and the other side is ecthing
> pattern.
> I have tried some methods to avoid it, but fail:
> 1. use nobal metal (Au) to protect PZT --> too expensive, and the Au
> will be etched.
> Its surface
> profile is like the moon surface.
> -->NG.
> 2.use thick PR to protect --> PR will be lifted.
> --> NG.
> 3.use jig to protect PZT --> use two o-rings to protect the wafer and
> locked by screw.
> when the thickness of the wafer
> is thin during the ecthing process,
> the wafer will break.
> --> NG.
>
> Can anyone give some suggestions to solve this problem?
> I will appreciate your response.
>
> Ralph
> _______________________________________________
> mems-talk@memsnet.org mailing list: to unsubscribe or change your list
> options, visit http://mail.mems-exchange.org/mailman/listinfo/mems-talk
> Hosted by the MEMS Exchange, providers of MEMS processing services.
> Visit us at http://www.mems-exchange.org/