The simplest solution would appear to be to turn the UV box 45
degrees. Have you tried that?
Jesse Fowler
UCLA/MAE Dept., 420 Westwood Plaza, Room 18-121, ENGR IV
Los Angeles, CA 90095-1597 | (310)825-3977
"Rule #6: There is no rule #6" -- Monty Python
"ARTICLE SIX: THIS ARTICLE IS ABOLISHED" -- Constitution of Afghanistan
On Mon, 4 Feb 2002, Michael Roper wrote:
> Hello all,
>
> I am trying to etch glass using photolithography/wet etching techniques,
> but I have made an observation during my lithography steps. I use a
> photomask with various horizontal and vertical lines (all 5 um in width),
> after exposing the photoresist (AZ1520) to UV light, developer, and
> finally Cr etch, I have noticed that the horizontal lines are ~twice as
> wide as the vertical lines. Interestingly, by keeping the mask in the
> same orientation to the glass, but moving the UV box 90 degrees, the
> vertical lines then become ~twice as big as the horizontal lines.
>
> I was wondering if this was a common occurence and if there is a simple
> solution....thought about spinning the photomask and glass or the UV light
> as the glass was being exposed, but just curious if there was a simpler
> solution? Thanks in advance to any help you can give.
>
> Mike
>
>
> Michael Roper
> University of Florida
> Chemistry Department
> 352-846-0838
> _______________________________________________
> mems-talk@memsnet.org mailing list: to unsubscribe or change your list
> options, visit http://mail.mems-exchange.org/mailman/listinfo/mems-talk
> Hosted by the MEMS Exchange, providers of MEMS processing services.
> Visit us at http://www.mems-exchange.org/