I'm no etch expert, but I would assume it would be at least 1 degree or
more, (since we're talking about a 500um thickness) so I don't think your
going to make it.
If you use the following equation for sidewall angle and use 17 for the
(top-bottom) you need a sidewall angle of 89.32.
sidewall angle (degrees) = arctan(thickness/(1/2(top-bottom))*(180/pi)
Subject: [mems-talk] DRIE sidewall angle
What is the expected tolerance for sidewall angle when DRIE 'etching a Si
substrate 500um thick?
I need to etch an arrayed die pattern consisting of two holes 125um and
155um diameter. The two holes are spaced 150 um apart and the die are ~1mm
apart. I want to etch 125 um diameter hole through the 500um thick wafer
and obtain a negative sidewall profile no greater than 1 degree and a
backside hole diameter of 125um +17um / -0um. Likewise, I need the 155um
diameter hole to have a negative sidewall profile no greater than 1 degree
and a backside hole diameter of 155um +17um / -0um.
Thank you in advance for any guidance,
Paul
_