Deep UV or heating of the wafer may also cause the problem. When does the
darkening occur? (Is it immediately visible after exposure or at some other
point in the process)? Do your structures look overexposed after
development?
On 17 January 2013 11:11, Jocelyn Ng wrote:
> Hello,
>
> I'm doing single layer SU8 2005, thickness ~6-7um. I use 60mJ/cm^-2 on
> sputtered gold surface. But somehow sometimes I notice that the edges of my
> pattern darkens, I suspect it's due to overexposed. But 60mJ is quite a low
> dose compared to the recommended one. I would appreciate any comments
> given. Thank you.
>
> Best Regards,
> Jocelyn
>
> Sent from my iPhone
> _______________________________________________
> Hosted by the MEMS and Nanotechnology Exchange, the country's leading
> provider of MEMS and Nanotechnology design and fabrication services.
> Visit us at http://www.mems-exchange.org
>
> Want to advertise to this community? See http://www.memsnet.org
>
> To unsubscribe:
> http://mail.mems-exchange.org/mailman/listinfo/mems-talk
>
_______________________________________________
Hosted by the MEMS and Nanotechnology Exchange, the country's leading
provider of MEMS and Nanotechnology design and fabrication services.
Visit us at http://www.mems-exchange.org
Want to advertise to this community? See http://www.memsnet.org
To unsubscribe:
http://mail.mems-exchange.org/mailman/listinfo/mems-talk