Try contacting Norm Nystrom at NYS Enterprises (408)867-5668. I beleive he
has done similar processing
Mac McReynolds
R&D Manager
Caliper Technologies Corp.
605 Fairchild Drive
Mountain View, CA 94043-2234
Tel: 650-623-0710
Fax: 650-623-0521
> ----------
> From: Connie Kathleen Smith
> Reply To: mems-talk@memsnet.org
> Sent: Thursday, March 14, 2002 7:45 AM
> To: mems-talk@memsnet.org
> Subject: [mems-talk] Anodic Bonding of Si to Pyrex
>
> I need to bond Pyrex to both sides of a silicon wafer. One of the pieces
> of Pyrex is a full 4 inch diameter wafer (same as Si wafer) with a
> thickness of 0.5 inches. This is used as the base for a flow cell etched
> into the wafer. The other piece of Pyrex is a cover slip for microscopy
> work so it is only 0.13 mm in thickness and a 50mm square.
>
> Has anyone ever anodically bonded pyrex to both sides? All the literature
> I read only describes the process for one side.
>
> Thank you,
> Connie Smith
> Department of Chemical Engineering
> Rice University
> 6100 Main MS 362
> Houston, TX 77005
> Phone 713-348-3507
> Fax 713-348-5478
> _______________________________________________
> mems-talk@memsnet.org mailing list: to unsubscribe or change your list
> options, visit http://mail.mems-exchange.org/mailman/listinfo/mems-talk
> Hosted by the MEMS Exchange, providers of MEMS processing services.
> Visit us at http://www.mems-exchange.org/